Filter
Top Products
Chapter 3 – Fax Class 2 Commands
Multi-Tech Systems, Inc. SocketModem MT5634SMIxx Reference Guide (S000263C) 60
Service Class Selection
Class 2.1 +FCLASS=<value>
The Service Class may be set by the host from the above choices using the
+FCLASS=<value> command. Once the result code is received from the modem.
Class 2 +FCLASS=<value>
Same as Class 2, except for the +FPR command. In Class 2, the serial port rate is
set by the speed at which the dial command is given when originating a fax call, the
speed at which the answer command is given when manually answering a fax call, or
the speed at which the last command is received before automatically answering the
call.
Request Manufacturer Identification
Class 2.1 +FMI?
The +FMI? command executes the V.25ter +GMI? command to request the name of
the modem’s manufacturer.
Example: AT+FMI?
Multi-Tech Systems
OK
Class 2 +FMFR?
The +FMFR? command requests the name of the modem’s manufacturer.
Request Model Identification
Class 2.1 +FMM?
The +FMM? command executes the V.25ter +GMM? command to request the
modem’s model number.
Example: AT+FMM?
MT5634ZBA-V92
OK
Class 2 +FMDL?
The +FMDL? command requests the modem’s model number.
Request Revision Identification
Class 2.1 +FMR?
The +FMR? command executes the V.25ter +GMR? command to request the
modem’s firmware revision number.
Example: AT+FMI?
------------
OK
Class 2 +FREV?
The +FREV? command requests the modem’s model number.