Multi-Tech Systems MT128ISA-UV Network Card User Manual


 
20
Chapter 2 - Installation
MT128ISA/PCI
tab. The screen displayed in fiigure 2-11 appears. Contact your ISP or network adminis-
trator if you require assistance in configuring your TCP/IP settings. Also check that you
have enabled, allow any authentication including clear text, in the Security settings. Click
OK.
Figure 2-11. Define Network Configuration
17. Select ISDN2 and click Configure to set up the appropriate values for the second line.
18. You have completed your ISDN driver installation and have added two NDISWAN adapt-
ers. Click Continue>Close. NT will bind the appropriate drivers to your adapter and you
will be prompted to restart your computer.
Windows NT Single Channel Access (NDISWAN)
Once your adapter is installed, you are ready to set up an ISDN Dial-Up Networking connection for single
channel access.
1. Select Start>Programs>Accessories>Dial-Up Networking. If there are no previous
entries in your phonebook, a dialog box appears stating The Phonebook is empty. Press
OK to add an Entry. The New Phone book entry wizard appears. Enter a name for your
new Phone Book entry. In the Dial Using field, select the IINWANNT NDISWAN adapter
you will use for this connection.
2. Next, enter the primary phone number for your ISP or remote server. If you need to
specify a Country, Region or Area code, click on the Telephony dialing properties box and
fill in your dialing information. If your ISP or remote server has more than one phone
number that can be dialed, click on Alternate Phone Numbers and add the phone
numbers to the screen.
3. On the Server tab, select the correct remote Server Type. Click on TCP/IP to set up
addresses for your remote server. Click OK to continue.
4. When complete, click OK>Close.
5. To use this new connection, open the Dial-Up Networking folder and select the NDISWAN
single channel access entry from the phonebook entry drop down list box. Click Dial.
6. Enter the user name and password for your ISP or remote server account and click OK.
Your adapter will connect in seconds.