Filter
Top Products
MVP428 Upgrade Installation MultiVOIP User Guide
408
Installation Instructions for MVP428 Upgrade Card
In this procedure, you will install an additional circuit board into the MVP410,
converting it from a 4-channel voip to an 8-channel voip.
Procedure in Detail
1. Power down and unplug the MVP410 unit.
2. Using a Phillips driver, remove the blank cover plate at the rear of the
MVP410 chassis. Save the screws.
screws on blank cover plate (2)
Figure D-2: Removing screws from blank cover plate
Summary: (A) Attach four standoffs to main circuit card.
(B) Mate the 60-pin connectors (male connector
on main circuit card; female on upgrade card).
(C) Attach upgrade card to main circuit card (4
screws).
-
-
*
*
(A)
*
Add standoffs here
(2 places).
-
Replace main card screws
with standoffs here
(2 places).
(B)
Mate 60-pin
connectors.
(C)
Attach upgrade card
(screws into standoffs
-- 4 places).
Figure D-1. Installation Summary