Filter
Top Products
33
Chapter 3 Troubleshooting
●
Messages List
The meanings of the main messages appearing on the screen are described below.
Messages Description
“Your current setting will be lost, if you perform “Auto
Screen Adjust”. Do you continue?”
Appears when performing [Auto Screen Adjust].
“Your current setting will be lost, if you perform “Auto
Range Adjust”. Do you continue?”
Appears when performing [Auto Range Adjust].
“Your current color data will be lost.” Appears when performing <Reset> in the <Color> menu.
Returns the color mode setting currently selected to the
default settings.
“If the eld rate is changed, no picture may be displayed on
screen. Do you change the setting?”
Appears when changing the settings of [Field Rate].
“If the USB setting is changed, the USB connection to the
selected PC will be lost. Do you change the setting?”
Appears when changing the settings of [USB].
• Do not change the settings in the following cases.
- When connecting a memory device such as a USB
memory to the monitor
The data may be lost and damaged. Be sure to change
the USB setting after removing the memory device.
- When an application such as a sound playback, etc.
works
The sound may not output if the setting is returned to
the original. Be sure to change the USB setting after
exiting from the application.
“The power will turn off soon. To cancel Off Timer, touch
the slide bar.”
Appears on the display from one minute before the power
turns off to the power-off time when the Off Timer is set.
Touching the slide bar while the message appears will
release the Off Timer setting and the message disappears.
“All settings except for the eld rate and USB are reset.” Appears when performing [Reset] in the Setting menu. Set
all the settings except for [Field Rate], [USB] and [Volume]
to the default settings.
“Volume adjust does not support this sound signal.” Appears when pressing [VOLUME] button on the remote
control or trying to display the shortcut menu of the volume
while receiving the sound signal not corresponding to the
monitor. In this case, no sound is output.