Filter
Top Products
Chapter 1 Installing and Configuring the SCXI-119X
SCXI-1190/1191/1192 User Manual 1-8 ni.com
5. Check the cable installation, making sure the connectors are securely
fastened at both ends.
6. Power on the SCXI chassis.
7. Power on the computer.
8. If you have already installed the appropriate software, you are ready to
configure the SCXI-119X. If you have not installed the appropriate
software, refer to the Installing the Software section.
Connecting the SCXI-119X to a DAQ Device in a PXI
Combination Chassis
To connect the SCXI-119X to a DAQ device in a PXI combination chassis,
such as the PXI-1010 or PXI-1011, you need the following items:
• PXI combination chassis with the SCXI modules installed
• National Instruments PXI MIO DAQ device, or a computer-based
instrument that is capable of controlling SCXI, installed in the right
most slot of the PXI section of the combination chassis
A PXI combination chassis can use both SCXI and PXI modules at the
same time. Because the connection between the SCXI backplane and the
PXI backplane is made through a local bus interface to a PXI multifunction
I/O module installed in the right most slot, no external cabling is needed to
connect one PXI multifunction I/O module to the SCXI bus.
You should have already installed your SCXI-119X module and any other
SCXI modules in the chassis according to their installation instructions.
To use the SCXI-119X module with a DAQ device or computer-based
instrument in a PXI combination chassis, turn on the SCXI chassis.
Consult your PXI chassis documentation, other SCXI module
documentation, and DAQ device or computer-based instrument
documentation for additional instructions and warnings.
If you have already installed the appropriate software, you are ready to
configure the SCXI-119X. If you have not installed the appropriate
software, refer to the Installing the Software section.