Filter
Top Products
Index
© National Instruments Corporation I-7 DAQCard-1200 User Manual
I/O connector
exceeding maximum ratings
(caution), 3-1
pin assignments (figure), 3-2
signal descriptions (table), 3-3
signal descriptions, 3-3
single-ended connections
floating signal sources (RSE
configuration), 3-11
ground-referenced signal sources (NRSE
configuration), 3-12
when to use, 3-11
software programming choices
National Instruments ADE software, 1-4
NI-DAQ driver software, 1-2
specifications
analog input
amplifier characteristics, A-2
dynamic characteristics, A-3
input characteristics, A-1
stability, A-4
transfer characteristics, A-2
analog output
dynamic characteristics, A-5
output characteristics, A-4
stability, A-5
transfer characteristics, A-4
voltage output, A-5
bus interface, A-7
digital I/O, A-5
physical, A-7
power requirements, A-7
timing I/O, A-6
square wave generation, 3-28
stability
analog input specifications, A-4
analog output specifications, A-5
STB* signal (table), 3-18
system integration, by National
Instruments, E-1
T
technical support resources, E-1
telephone technical support, E-2
theory of operation
analog input
circuitry, 4-6
data acquisition rates, 4-9
data acquisition timing, 4-8
analog output
circuitry, 4-10
DAC timing, 4-11
power-on state, 4-11
block diagram of DAQCard-1200, 4-1
digital I/O, 4-12
functional overview, 4-1
PC card I/O channel interface
circuitry, 4-2
timing, 4-3
time-lapse measurement, 3-29
timing circuitry
illustration, 4-4
theory of operation, 4-3
timing I/O specifications, A-6
timing signal connections. See data acquisition
timing connections; general-purpose timing
signal conections
timing specifications, digital I/O
mode 1 input timing, 3-19
mode 1 output timing, 3-20
mode 2 bidirectional timing, 3-20
training, customer, E-1
transfer characteristics
analog input specifications, A-2
analog output specifications, A-4
troubleshooting resources, E-1