Filter
Top Products
4-20 Windows Setup
The additional ft Update CD will be used. Are you sure [Y,N]?
The additional ft Update CD will not be used. Are you sure [Y,N]?
If you have an additional ft Update CD and wish to use it,
insert the CD-ROM into the CD-ROM drive.
Use an additional ft Update CD [Y,N]?Y
The additional ft Update CD will be used. Are you sure [Y,N]?Y
Insert the ft Update CD into the CD-ROM drive and press ENTER.
CD-ROM and NEC EXPRESSBUILDER will be started.
13. After the system is restarted, the following message will appear:
If you have “NEC Express5800/ft series ft Update CD” handy, enter “Y”.
If you do not have “NEC Express5800/ft series ft Update CD” handy and perform
installation using “NEC EXPRESSBUILDER” only, enter “N”.
14. A message for reconfirming usage of the “NEC Express5800/ft series ft Update CD” will
appear. Enter “Y” if the selection is correct. Enter “N” if it is wrong.
Or
15. <Only when the usage of the “NEC Express5800/ft series ft Update CD” is selected>
The message below will appear. Insert ft Update CD into CD-ROM drive and press Enter
key.
IMPORTANT: When the usage of the “NEC Express5800/ft series ft Update CD” is
not selected, the above message will not appear. Go on to 11.
16. <Only when the usage of the “NEC Express5800/ft series ft Update CD” is selected>
The message below will appear. Wait about 3 minutes until copying is completed.
Copying necessary NEC Express5800/ft series system software to the
system drive... Approximately 3 minutes.
N
ecessary NEC Express5800/ft series software has been copied.
If you have an additional ft Update CD and wish to use it,
insert the CD-ROM into the CD-ROM drive.
Use an additional ft Update CD [Y,N]?