NEC LT170 Projector User Manual


 
E-9
1
2
30°
30°
7m / 22 feet
INTRODUCTION
Battery Installation
1. Press firmly and slide the battery cover off.
2. Remove both old batteries and install new ones (AAA). Ensure that
you have the batteries' polarity (+/-) aligned correctly.
3. Slip the cover back over the batteries until it snaps into place. Do not
mix different types of batteries or new and old batteries.
Remote Control Precautions
Handle the remote control carefully.
If the remote control gets wet, wipe it dry immediately.
•Avoid excessive heat and humidity.
If you will not be using the remote control for a long time, remove the
batteries.
Do not place the batteries upside down.
Do not use new and old batteries together, or use different types of
batteries together
Operating Range for Wireless Remote Control
Remote control
Remote sensor on
projector cabinet
Actual operating range may differ from the above drawing.
The infrared signal operates by line-of-sight up to a distance of about
22 feet/7 m and within a 60-degree angle of the remote sensor on the
projector cabinet.
The projector will not respond if there are objects between the remote
control and the sensor, or if strong light falls on the sensor. Weak bat-
teries will also prevent the remote control from properly operating the
projector.