Filter
Top Products
3-20
Configuring Your System
Symbios Configuration Utility
The Symbios Configuration Utility detects the two SCSI host adapters located
on the system board. Use the utility to:
!
Change adapter and SCSI device default values
!
Check and/or change SCSI device settings that may conflict with those of
other devices in the server.
!
Perform low-level formatting or verify operations on SCSI disk drives.
Running the Symbios Configuration Utility
1.
Power-on the system. The system boots up.
2.
When this message appears on the video monitor:
Press Ctrl-C to start the Symbios Configuration Utility
Press Ctrl+C to run this utility.
3.
The utility starts and the Main Menu displays.
Symbios Configuration Utility Main Menu
Status
Adapter
Port
Number IRQ Level
Current Next Boot
NVRAM
Found
SYM53C875 F800 11 On On* Yes
SYM53C875 F400 10 On On* Yes
Change Adapter Status – Press ENTER twice to change adapter Next Boot Status.
Adapter Boot Order – Press ENTER to select and change boot order of each SCSI adapter.
Additional Adapter Configuration – Not used.
Display Mode-Verbose – Press ENTER to change display mode.
Mono/Color – Press ENTER to change display from black/white to color.
Language – Not used.
Help/Quit
*Next Boot Status for this controller must be turned
OFF
if you install the optional
Mylex AcceleRAID
™
150 (SecuRAID 110) or Mylex AcceleRAID
™
250 (SecuRAID 210)
Controller board in your system. Refer to “Change Adapter Status” above.