Filter
Top Products
3-22
Configuring Your System
To change device configuration parameters, perform the following steps:
1.
At the SCSI Configuration Utility Main Menu, select the adapter which
connects to the SCSI device you are reconfiguring. The first adapter listed
controls the operation of the hard disk drives; the second adapter controls
any SCSI removable media devices installed in your system. Press ENTER.
2.
Select “Device Selections” and press ENTER. The Devices 0 to 7 screen
displays.
3.
Select the SCSI device you are reconfiguring and press ENTER. If you are
configuring SCSI Hard Disk Drives, refer to the SYM53C875 Adapter 1
Table below; if you are configuring SCSI Removable Media Devices, refer
to the SYM53C875 Adapter 2 Table below for recommended settings.
SYM53C875 Adapter 1 – SCSI Hard Disk Drives
Description
Recommended Setting or
Display Only Your Configuration
Device Selections Press ENTER for menu.
Select device and press
ENTER.
Dev0 Dev1 Dev2 Dev3
Sync Rate 40
Width (bits) 16
Disconnect On
Read/Write I/O timeout
(secs)
10
Scan for device at boot time Yes
Scan for SCSI LUNS No
Queue Tags On