Filter
Top Products
30
5. Setting the LAN Setting of Personal Computer
([Example] Wireless LAN of Windows Vista: Ad Hoc connection)
This section explains the procedure for Ad Hoc connection of wireless LAN between the personal
computer and projector, by using the wireless network setting function with Windows Vista
Ultimate.
Preparation:
• If the computer you are using does not have a built-in wireless LAN unit, install a
commercially available wireless LAN card driver to your personal computer, and complete
setup of the wireless LAN card. For how to install the driver, refer to the User’s Manual of
the wireless LAN card.
• Check the display of the Windows Vista taskbar. If a network connection utility dedicated
to a wireless LAN unit or a wireless LAN card is executed, terminate that utility.
• Make the wireless LAN setting of the projector. For details, refer to “4. Setting the LAN
Settings of Projector” (
page 15).
Shown below is an example of the wireless LAN settings for the projector.
[Example of settings for projector]
Contents
IP Address
Subnet Mask
SSID
NETWORK TYPE
WEP
KEY SELECT
KEY 1
Settings
192.168.100.10
255.255.255.0
NECPJ
AD HOC
64bit
KEY1
NECDS
1
Click Windows [Start] → [Control Panel].
The “Control Panel” window will be displayed.
2
Click the [View network status and tasks] link that is displayed under [Network
and Internet].
5. Setting the LAN Setting of Personal Computer
([Example] Wireless LAN of Windows Vista: Ad Hoc connection)