Filter
Top Products
YML894 Rev1 N3G002W 3G Wireless Router User GuideN3G002W 3G Wireless Router User Guide
www.netcomm.com.au 23
Basic Setting > Primary Setup
This Page allows you to change the LAN (Local Area Network) settings on your N3G002W wireless router and
the WAN (Wide Area Network) connection.
Note: This example shows WAN connection for Telstra Next G connection.
1. LAN IP Address: the local IP address of this device.
2. LAN Netmask: the Netmask of the local IP address
3. WAN’s MAC Address: The WAN’s MAC of this device. If you want to clone the MAC address from your
computer network card, just click the Clone MAC and click Save.
4. WAN Type: WAN connection type of your ISP. Each WAN type will give you the option to enter the required
information. You can select one of the following options.
a. Static IP Address. For connection with static IP address.
b. Dynamic IP Address. For connection with dynamic IP address. Mostly used when the N3G002W unit
is in use in conjunction with another modem/router.
c. Dynamic IP Address with Road Runner Session Management. When using the N3G002W with Telstra
Bigpond Cable service.
d. PPP over Ethernet. For connection with PPPoE service. Mostly used when the N3G002W unit is