Filter
Top Products
N3G002W 3G Wireless Router User Guide YML894 Rev1
54 www.netcomm.com.au
Advanced Setting > Performance
This page give you option to change the wireless advance settings.
1. Beacon Interval. Beacons are packets sent by the unit to synchronize to wireless clients. The default value
is set to 100 milliseconds and the acceptable value is 1 to 1000.
2. DTIM interval. The default value is set to 3 and the acceptable value is 1 to 65535. A DTIM is a
countdown informing clients of the next window for listening to broadcast and multicast messages. When
the unit has buffered broadcast or multicast messages for associated clients, it sends the next DTIM with
a DTIM Interval value. AP clients hear the beacons and awaken to receive the broadcast and multicast
messages.
3. Wireless mode. Select wireless connection mode for wireless connection. G mode will only allows
connection from wireless clients with 802.11g connection. Please use mixed mode unless you want to
prevent older wireless (802.11b) adapter to connect.
4. TX Rates. Default rate is Auto and operates at 54Mbps data rate when possible but drop to lower rates
when necessary, dependent on signal strength and the capacity of the wireless client station.
5. SSID Broadcast. Choose enable or disable the wireless SSID broadcast. By turning off the broadcast of
the SSID, it is possible to make your wireless network nearly invisible.
6. Speed Enhanced Mode. This is Tx Brust function in only available for Ralink wireless solution.
7. Antenna Transmit Power: Default is 100% 17dbM. You can either increase or decreases the antenna
transmit power.
Click Save to save the settings and Undo to cancel.