Filter
Top Products
Reference Manual for the Model DM602 ADSL Modem
Setting Up the Hardware 2-7
Connecting the Power Adapter
To connect the power adapter to the modem:
1. Plug the connector of the power adapter into outlet on the rear panel of the modem.
2. Plug the other end of the adapter into an AC power outlet.
3. Verify that the PWR LED on the modem is lit.
Verifying Power
After applying power to the modem, complete the following steps to verify that power is correctly
applied:
1. When power is first applied, verify that the Power LED comes on.
All LEDs will be briefly tested.
2. After approximately 10 seconds, verify that the local Ethernet or USB port LED is lit for the
port that is connected to your computer.
3. If a port’s LED is lit, a link has been established to the connected device. If a local Ethernet
port is connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10
Mbps, the LED should be yellow.
DM602.book Page 7 Monday, August 12, 2002 6:09 PM