Filter
Top Products
Get Started
11
M6100 Series Switches
N - Do nothing and go to the next question.
Q - Quit.
? - Help.
(C/D/N/Q/?)?
If the switch already was assigned an IP address and you do not want to change the IP
address again, type N.
ezconfig displays the current IP address and subnet mask. By default, the network DHCP
server assigns IP addresses automatically according to DHCP protocol. However, you
can overwrite the DHCP client mode by assigning a fixed IP address here. Once a fixed
IP address is assigned, ezconfig automatically disables DHCP client mode and assigns
the static IP address to the management VLAN.
4. (Optional) Enable the routing interface.
Do you want routing to be enabled (Y/N)?
To enable the routing interface, type Y.
The management VLAN becomes the routing VLAN, ezconfig sets the IP address to the
address of the routing VLAN, and ezconfig creates a default gateway.
Note: If you type N
, ezconfig sets the IP address and gateway to the network
interface.
5. Assign a switch name and location information.
Enter alphanumeric characters only. Characters such as # and $ are not supported. The
number of characters cannot exceed 31 characters.
Assigning System Name, System Location and System Contact to your switch management
Current Configuration
--------------------------------
System Name:
System Location:
System Contact:
Do you want to assign switch name and location information? (Y/N/Q)
6. Save the configuration by typing Y.
There are changes detected, do you wish to save the changes permanently (Y/N)?
y
The configuration changes have been saved successfully.
Please enter 'show running-config' to see the final configuration.
Thanks for using EzConfig!
Your changes are saved in flash memory (permanent storage).