Filter
Top Products
Preparing Your Network C-1
202-10051-01, March 2005
Appendix C
Preparing Your Network
This appendix describes how to prepare your network to connect to the Internet through the
WGR826V 54 Mbps Wireless Router with Phone Adapter and how to verify the readiness of
broadband Internet service from an Internet service provider (ISP).
What You Need To Use a Router with a Broadband Modem
You need to prepare these three things before you begin:
Cabling and Computer Hardware
To use the WGR826V Wireless Router on your network, each computer must have an 802.11g or
802.11b wireless adapter or an installed Ethernet Network Interface Card (NIC) and an Ethernet
cable. If the computer will connect to your network using an Ethernet NIC at 100 Mbps, you must
use a Category 5 (Cat 5) cable such as the one provided with your router. For an explanation of
Ethernet cabling, see “Ethernet Cabling“ on page B-11. The cable or DSL broadband modem must
provide a standard 10 Mbps (10BASE-T) or 100 Mbps (100BASE-Tx) Ethernet interface.
Computer Network Configuration Requirements
The WGR826V includes a built-in Web Configuration Manager. To access the configuration
menus on the WGR826V, your must use a Java-enabled Web browser program which supports
HTTP uploads such as Microsoft Internet Explorer or Netscape Navigator. Use Internet Explorer
or Netscape Navigator 4.0 or above.
Note: If an ISP technician configured your computer during the installation of a
broadband modem, or if you configured it using instructions provided by your ISP, you
may need to copy the current configuration information for use in the configuration of
your firewall. Write down this information before reconfiguring your computers. Refer
to “Obtaining ISP Configuration Information for Windows Computers” on page C-21 or
“Obtaining ISP Configuration Information for Macintosh Computers” on page C-22 for
further information.