NETGEAR RN31400-100NAS Network Hardware User Manual


 
NETGEAR ReadyNAS User Guide
3-8 Maintenance and Administration
v1.0, October 2007
The following figure illustrates the default configuration with redundancy in your ReadyNAS
NV+.
You can switch between the X-RAID Expandable Volume mode and the RAID 0/1/5 Flexible
Volume mode only if you want to change the default configuration. It is not necessary to perform
this procedure every time you boot up the system. The device remains in the selected mode until
explicitly changed.
To reconfigure your RAID setup:
1. Power off the device.
2. Use a paper clip or push pin to press the System Reset switch. Press the System Reset switch
for 30 seconds while powering on the device.
The four LEDs will flash for approximately 30 seconds.
3. When the LEDS are on, but not flashing, release the reset switch.
Figure 3-8
Warning: Performing a Factory Default will erase all your data on the hard disks.