Filter
Top Products
NETGEAR ReadyNAS User Guide
1-54 Configuring Your ReadyNAS
v1.0, October 2007
Alerts Settings
This ReadyNAS device has been preconfigured with mandatory and optional alerts for various
system device warnings and failures. The Settings tab allows you to control the settings for the
optional alerts.
NETGEAR strongly recommends that you keep all alerts enabled; however, you might choose to
disable an alert if you are aware of a problem and wish to temporarily disable it.
At the bottom of the screen in the Other Alert Settings section, there are a couple of additional
options of note. Selecting the Power-off NAS when a disk fails or no longer responds option
gracefully powers off the ReadyNAS if a disk failure or a disk remove event is detected. Selecting
the Power-off NAS when disk temperature exceeds safe level gracefully powers off the
ReadyNAS when the disk temperature exceeds the nominal range.
SNMP
If you utilize an SNMP management system such as HP OpenView or CA UniCenter to monitor
devices on your network, you can set up the ReadyNAS device to work within this infrastructure.
Figure 1-58