Filter
Top Products
NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH
35
Login user to a port and connect the user port to a host port
Action (from Keypad) Reaction of SERIMUX
1. Press USER - The LED “User” will illuminate.
- The port 0 LED will be illuminated, the other port LEDs will be OFF.
2. Enter the user number - The corresponding port LED will illuminate
3. Press PORT - The LED "Port" will illuminate
4. Enter the user port
number
- The corresponding port LED will illuminate. The other port LEDs will be OFF.
5. Press PORT again - The LED "Port" will illuminate
6. Enter the host port
number
- The corresponding port LED will illuminate. The other port LEDs will be OFF.
7. Press ENTER - The User main menu will be displayed on the terminal application on the user port: (see
Figure 22 on page 27 )
- If command is successful the “Admin”,”Port”,”Discon”.,”User” LEDs will illuminate together.
They will turn OFF after 30 seconds or when any other key is pressed.
The user will be connected if:
– the specified user is enabled, and is not logged in;
– the specified ports are accessible to the user;
– the user port is not otherwise already connected and the port type is “User”.
– the host port is not otherwise already connected and the port type is “Host”.
Disconnect and logout a user
Action (from Keypad) Reaction of SERIMUX
1. Press DISCON - The LED “Discon” will illuminate.
2. Press USER - The LED “User” will illuminate.
3. Enter the user number - The corresponding port LED will illuminate, the other port LEDs will be OFF
4. Press ENTER - The LEDs “Port", “Admin”, "User", and "Discon" will illuminate briefly.
Connect 2 host ports
Action (from Keypad) Reaction of SERIMUX
1. Press PORT - The LED “Port” will illuminate.
- The port 0 LED will be illuminated. The other port LEDs will be OFF.
2. Enter the first port number - The corresponding port LED will illuminate, the other port LEDs will be OFF
3. Press PORT again - The LED “Port” will illuminate. The port 0 LED will be illuminated, the other port LEDs will be
OFF.
4. Enter the second port
number (to connect the
first port number to)
- The corresponding port LED will illuminate. The other port LEDs will be OFF.
5. Press ENTER - If command is successful the “Admin”,”Port”,”Discon”.,”User” LEDs will illuminate together.
They will turn OFF after 30 seconds or when any other key is pressed.
The two host ports will be connected if:
– the ports are not connected
– the ports type is “Host”.