Filter
Top Products
NTI AUDIO/HD VIDEO MATRIX SWITCH
21
Output Names
From the Administration menu, the Video or Audio Output
Names page can be displayed. (Selected separately from
the menu.) These pages enable the Administrator to
change the names of the output ports displayed on the
Switch page. To change an Output Name, enter the
name of the port for the desired output port number, and
press "Save".
Figure 15- Web interface Output Names page
Scan Mode
From the Administration menu the "Outputs Scan Mode
Settings" page can be displayed. This page shows a table
with all outputs, the status of Scan Mode for each, and edit
boxes for dwell time settings (in seconds) for each output.
Each setting can be edited with a value from 0-255. A setting
of 0 seconds will disable Scan Mode for that output.
If Scan Mode is disabled for a specific output, then the video
to that output will only change as decided by the administrator.
To change Scan Mode from "Off" to "On", simply enter a dwell
time value in a box under "Dwell Time" for any Output and
press "Apply". Only those boxes with a value of 0 will
indicate Scan Mode is "Off" for the respective output.
Scan Mode dwell time settings can also be configured
through the LCD menu (page 7), Telnet commands
(page 14), or through the RS232 Command Protocol
(page 10).
Press "Clear All" to set all output scan mode settings to "Off".
For more on Scan Mode, see page 9.
Figure 16- Web interface Scan Mode page
Note: Only the changes to the port
directly to the left of the Save button will
be saved. All other changes to ports
without pressing the port's respective
Save button will be discarded. All port
names must be no more than 16
characters in length and only
alphanumeric characters may be used.