Filter
Top Products
Access point parameters
11
zone_privacy Advanced
Access
Point
“off” “on” or “off” If set to “on”, the AP
blocks traffic from
being passed directly
between radio clients
(this has the effect of
blocking peer-peer
networking)
snmp_contact SNMP “Contact” up to 32
characters
SNMP contact name
(from the RFC1213
MIB)
snmp_sys_name SNMP “Sys Name” up to 32
characters
SNMP system name
(from the RFC1213
MIB)
snmp_location SNMP “Location” up to 64
characters
SNMP location data
(from the RFC1213
MIB)
dhcp_mode DHCP “disabled” “off”,
“disabled”,
“client”,
“server”
Used to select DHCP
operation for the AP.
By default, this will
be disabled, but
server and client
operation can be
selected.
dhcp_base DHCP 192.168.5.100 IP address The base address of
the IP pool for DHCP
server operation.
dhcp_pool DHCP 16 1–64 The number of
entries in the pool for
the DHCP server.
dhcp_gateway DHCP none IP address The gateway address
for DHCP clients.
Name
(command line)
Config
Web page
Factory default Valid range Description