Filter
Top Products
46 – 3G10WV HSPA Wi-Fi Router with Voice
7.1 Local Area Network (LAN)
This screen allows you to configure the Local Area Network (LAN) interface on your Router.
See the field descriptions below for more details.
Option Description
IP Address
Enter the IP address for the LAN interface
Subnet Mask
Enter the subnet mask for the LAN interface
Enable UPnP
Tick the box to enable Universal Plug and Play
Enable Half-Bridge
The HSPA 7.2 Mbps Wi-Fi Router can be set up as a half- transparent bridge to
cope with some special applications such as VPN pass-through. By default half-
bridge is off. Please refer to Appendix B for more information.
Enable Internet Group
Management Protocol
(IGMP) Snooping
Enable by ticking the box
Standard Mode: In standard mode, multicast traffic will flood to all bridge ports when
no client subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data traffic will be blocked. When there
are no client subscriptions to a multicast group, it will not flood to the bridge ports.
Dynamic Host
Configuration Protocol
(DHCP) Server
Select Enable DHCP server and enter your starting and ending IP addresses and
the lease time. This setting configures the router to automatically assign IP, default
gateway and DNS server addresses to every DHCP client on your LAN
Enable NAT
To enable/disable Network Address Translation (NAT, please refer to 7.2 for NAT
setting). By default NAT is enabled.
Option 42, 66,150,160
These options are used for special DHCP set up.
Static IP Lease List
To specify the IP address assigned through DHCP according to the MAC address
of the hosts connected to HSPA 7.2 Mbps Wi-Fi Router.