Filter
Top Products
92 – 3G10WV HSPA Wi-Fi Router with Voice
• none: disable the service.
• local: enable the service at LAN side only
• remote: enable the service at WAN side only
• both: enable the service at both LAN and WAN sides.
(2) To add an entry of IP range that to be enable to manage the gateway. Subnet mask of 255.255.255.255 is
for a host with the specific IP address.
Synopsis: remoteaccess iprange --add <IP address> <Subnet mask> <none|local|remote|both>
<none|local|remote|both>
• none: forbid the IP range to manage the 3G10WV.
• local: permit the IP range to manage the 3G10WV from LAN side only.
• remote: permit the IP range to manage the 3G10WV from WAN side only.
• both: permit the IP range to manage the 3G10WV from both LAN and WAN.
(3) To delete an entry of IP range that to be enable to manage the gateway.
Synopsis: remoteaccess iprange --remove <IP address> <Subnet mask>
(4)To enable or disable the all the IP ranges defined by command (2).
Synopsis: remoteaccess accesscontrolmode <--enable <0|1> >
* Argument --enable 1 is to enable the access list; argument --enable 0 is to disable the access list;. Please
note (a) enabling access list mode is only for the case of at least one IP list is created; (b) after removing the
last entry in the table, the access list mode will be disabled automatically. This is to avoid no IP being on the
list when access mode is enabled; it will cause the router no being able to be managed by any IP address. The
only solution under this circumstance is to reset 3G10WVT gateway back to factory default by press the reset
button on the back of the gateway for over 8 seconds.
(5) To display all current settings for remote access.
Synopsis: remoteaccess show
(6) To view the usage of “remoteacesss” command.
Synopsis: remoteaccess –help