Filter
Top Products
3G10WV HSPA Wi-Fi Router with Voice – 93
config AP mode.
Default value : ap
--restrict <enabled|disabled>
config bridge restrict mode.
Default value : disabled
--rmac1 <MACaddress>
--rmac2 <MACaddress>
--rmac3 <MACaddress>
--rmac4 <MACaddress>
config remote bridge MAC address
NOTE 4:
You should enable the option - “restrict” before setting any restrict MAC address (setting --rmac1~4) or your
restrict MAC address setting will be ignored.
After the version – C40_R01, the wireless driver – 3.91.15.0 supports both BCM4318 and BCM4306; Version
- C39_R02 with the wireless driver - 3.61.13.0 supports only BCM4306;
The behavior of wds is similar to connect two or more AP using a hub, be aware of the IP assignment to
prevent assigning two or more hosts / STAs to the same IP address. You could enable only one DHCP server in
one router and disable all other’s to avoid the conflict of the IP assignment.
WDS CLI does NOT support Enable(Scan) mode in Bridge Restrict while WEB does. If you set Bridge Restrict to
Enable(Scan) mode, the CLI will show Bridge Restrict disabled.
Example 4:
After example 3, we want to use wds to connect with the other AP which has disabled the DHCP server (NOTE
4) and has MAC address - 00:12:34:56:78:9a; we can achieve the goal using the following command.
wlan wds --mode wds --restrict enabled --rmac1 00:12:34:56:78:9a
info: Show the configurations of WLAN interface and the information of stations connected to this AP.
Options for the info command
wlan info [--config] [--security]
[--macfilter] [--wds] [--station]
--config
list parameters of config command
--security
list parameters of security command