Filter
Top Products
Revision 04062009 Page 8 of 52
702-W DIN RAIL MOUNTING
Install the unit on a standard 35mm Din-Rail. Recess the 702-W unit to allow at least 3” of horizontal
clearance for copper cable bend radius.
DIN-Rail Mounting
To mount the unit to the 35mm DIN-Rail, place
the top edge of the bracket on the back of the
unit against the DIN-Rail's top edge at an upward
angle. Then, rotate the unit downward and back
against the DIN-Rail until it snaps into place.
You may need to adjust the angle of the antennas
depending on the amount of clearance available.
To remove the vertically mounted unit from
35mm DIN-Rail, carefully apply downward
pressure on the unit. Then, rotate the unit
upward and away from the 35mm DIN-Rail and
lift up for removal.
19” Universal Rack Mounting
Most N-Tron™ products are designed to be
mounted on industry standard 35mm DIN-Rail.
However, DIN-Rail mounting may not be suitable
for all applications. Our Universal Rack Mount
Kit (P/N: URMK) may be used to mount the 702-
W to standard 19" racks as an option.