Filter
Top Products
(Revised 2010-9-27) Page 12 of 159
DIN RAIL MOUNTING
Install the unit on a standard 35mm Din-Rail. Recess the unit to allow at least 3‖ of horizontal clearance for
copper cable bend radius. Recess the unit to allow at least 5‖ of horizontal clearance for fiber cable bend
radius. There should be at least 3‖ of clearance on both the top and bottom of the unit to allow proper
ventilation.
To install the unit to 35mm industrial DIN rail,
place the top edge of the included mounting
bracket on the back of the unit against the DIN rail
at a 15° angle as shown. Rotate the bottom of the
unit to the back (away from you) until it snaps into
place.
To remove the unit from the 35mm industrial
DIN rail, pull forward on the unit until it disengages
from the bottom of the DIN rail. Rotate the bottom
of the unit towards you and up at an approximate
15° upward angle to completely remove the unit.
URMK CPMA-1
Most N-Tron™ products are designed to be mounted on industry standard 35mm DIN rail. However,
DIN rail mounting may not be suitable for all applications. Our Optional Universal Rack Mount Kit
(P/N: URMK) may be used to mount the enclosure to standard 19" racks, and our Optional Factory
Installed Panel Mount Assembly (P/N: CPMA-1) may be used to mount the enclosure to a panel or
any other flat surface.