(Revised 2010-9-27) Page 137 of 159
CLI Commands, Continued…
Save or Reset the Configuration Settings
Save or reset configuration settings
save
save current running configuration settings.
reset
reset configuration settings to factory defaults.
N-TRON/Admin> config save
Save Settings...
Settings have been saved.
N-TRON/Admin> config reset
Resetting to factory defaults...
Load factory default settings [y/n]?y
Keep IP, subnet mask, and gateway addresses [y/n]?y
Keep current user names and passwords [y/n]?y
…
Show or Set IGMP Configuration
Show or set IGMP configuration. If no parameters are specified, this command will show
the IGMP configuration (same as -show parameter).
igmp [-show] [-status state]
-show
Show configuration.
-status state
Set the IGMP status to e(nabled) or d(isabled).
N-TRON/Admin> igmp –show
IGMP Status : Enabled
IGMP Version : 2
Query Mode : Auto
CIP Querier Status : 2, Active-Auto
Active Querier IP : 192.168.1.250
Router Mode : Auto
Manual Router Ports : (None)
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin> igmp –status disabled
IGMP Status : Disabled
IGMP Version : 2
Query Mode : Auto
CIP Querier Status : 2, Active-Auto
Active Querier IP : 192.168.1.250
Router Mode : Auto
Manual Router Ports : (None)
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin>…
