Filter
Top Products
INSTALLATION AND RELOCATION PROCEDURE > 27
3. Remove the two screws on top of the metal cover (1), and pull the
metal cover upwards (2).
Closing the printer
1. Align and insert the protrusion at the bottom of the metal cover
into the notch of the printer (1), and tighten the two screws on the
top of the cover (2).
2. Align and insert the protrusions at the top of the right detachable
cover into the notches of the printer (1). Fit the protrusions at the
bottom of the cover into the printer (2) and slide the cover towards
the front of the printer (3).
3. Tighten the screw on the right detachable cover.