Filter
Top Products
Menu Functions • 59
FRAME TYPE AUTO
802.2
802.3
ETHERNET II
SNAP
Selects the Ethernet MAC layer frame
type.
IP ADDRESS
SET
AUTO
MANUAL
Change this to Manual to specify the IP
address through the front panel.(see
next entry) Required for non-DHCP
networks.
IP ADDRESS xxx.xxx.xxx.xxx
Default =
192.168.100.100
Current assigned IP address. To
change:
• Press ENTER.
• Use +/– keys to increment first octet.
• Press ENTER to move on to the next
octet.
• Use +/– keys to increment second
octet.
• Press ENTER to move on to the next
octet.
• Use +/– keys to increment third octet.
• Press ENTER to move on to the last
octet.
• Use +/– keys to increment 1st octet.
• Press ENTER to register the new
address.
SUBNET MASK xxx.xxx.xxx.xxx
Default =
255.255.255.000
Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx
Default =
192.168.100.254
Current assigned gateway address. To
change, proceed as above.
INITIALIZE
NIC?
[EXECUTE] Initializes the network card.
WEB/IPP ENABLE
DISABLE
Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.
Network Menu (continued)
Note: Factory default settings are shown in bold.
Item Settings Explanation