Filter
Top Products
Microline 8810 User’s Guide
71
5. Press MODE repeatedly until the setting you wish to engage displays:
2.12 mm (1/12”), 3.18 mm (1/8”), 6.35 mm (1/4”), 7.62 mm (3/10”),
8.47 mm (1/3”), 10.58 mm (5/12”), 21.59 mm (0.85"), 23.28 mm
(11/12”), 25.4 mm (1”), or 27.52 mm (13/12”).
6. Press LOAD: this saves your setting and exits the menu mode.
Use 1Chr Set Pos
You can set and use two different custom Top of Forms:
• Front Feed (continuous forms)
• Manual Feed (single forms).
Front Feed (Continuous Forms)
1. Make sure the printer is set to the Front Feed path.
2. Press SEL, then press LOAD to park the continuous forms.
3. Simultaneously press SHIFT and SEL.
The continuous forms move to the printer’s default TOF position
(1/4-inch [6.4 mm]).
The display reads 1CHR. SET POS.
4. Adjust the print start position as follows:
a. If you are fine tuning the TOF you set for a preprinted form, you
can move the form to the position you last set for Front Feed 1Chr.
Set Pos. by pressing the FF switch.
b. To move the TOF further down on the page (print paper advances
further into the printer):
– In 1/144-inch (0.18 mm) increments: press and hold the SHIFT
switch, then press FF.
– In 10/144-inch (1.75 mm) increments: press and hold the SHIFT
switch, then press SEL.
– One line at a time: press LF.
8810_3_crop.jpg