Oki 8810 Printer User Manual


 
Microline 8810 User’s Guide
23
6. Close the tractor covers and fine tune the position of the right tractor
until the holes in the paper are centered on the pins, then push back the
right tractor lock lever.
7. Lower the platform.
8. Position the continuous forms stack below the printer with no more than
about 1 inch (3 cm) offset (1).
Switch between Single Sheets and Continuous Forms
Note If the optional Cut Sheet Feeder (CSF) and/or Rear Push Tractor are
installed, additional paper paths (e.g., Front CSF, Rear CSF, etc.)
appear on the display.
F5-07a.JPG
F5-08a.JPG
8810_3_crop.JPG