Oki 8810 Printer User Manual


 
Microline 8810 User’s Guide
58
Gap Pos.
When Auto Gap detection is enabled, this sets how far in from
the left edge of the form the gap detection begins: 2 inches (51
mm) [the default] or 4 inches (102 mm).
Graphics
The default is Bi-directional. Changing to Uni-directional will
improve the print registration, but slow the print speed.
Graphics Data
Sets graphics data to print 7 Bits [the default] or 8 Bits.
High Skip
The default is Yes. This enables the low-vibration mode, which
reduces printer vibration during printing. To switch low-vibration
mode off, change this setting to No.
Host Interface
Choose the interface mode: Auto Interface [the default],
Parallel, USB, or Option I/F.
I-Prime
The default is Enable: print out the buffer contents when the
I-Prime signal is received. Change to Disable if you wish the
printer to ignore the I-Prime signal.
I/F Time Out
Appears only if Host Interface is set to Auto Interface [the
default].
Choose the amount of time the printer waits (while receiving
data) before going into idle mode: 15 sec [the default], 30 sec,
45 sec, 1 min, 2 min, 3 min, 4 min, or 5 min.
If your software spends a long time processing between portions
of data it feeds to the printer, choose a longer time interval value
to keep your printer from dumping the received data while it is
waiting for more.
Impact Mode
Selects the print mode, Normal [the default] or Quiet, engaged
on power up.