Filter
Top Products
Microline 8810 User’s Guide
50
Applies to continuous forms fed through the optional Rear Push
Tractor.
Adjusts the set horizontal location for printing the first character
on a form when using manual feed from the platform. Selectable
settings: Left 10, Left 9, … Left 2, Left 1, Right 1, Right 2 … Right
9, Right 10, in increments of 1/180 inch (0.14 mm).
The default is 0.
Align1 Pos. Adj.
Align2 Pos. Adj.
Align3 Pos. Adj
Align4 Pos. Adj.
Note To use this setting, The corresponding Align 1/ Align 2/
Align 3 / Align 4 setting must be selected for Auto Align or
Auto Align (POW).
Use these to set up to four custom values for the left margin on
forms when you are using manual feed from the platform. This
represents the distance from the left edge of the page to the left
side of the first printed character. Adjusts within a range of 0 to
45.4 mm, in 1/90-inch [0.26 mm] increments.
The default setting is 5.1 mm.
Auto Align
Applies only to manual feed from the platform.
When Auto Align is engaged (the printer default), you can use
the front panel switches to change to a different preset left
margin value (Align 1, 2, 3, or 4). The values are set in the menu
under Align1 Pos. Adj., etc.
This lets you quickly switch to another form which requires a
different left margin. For more information on using the front
panel to change Align settings, see page 11.
If MemoryAutoAlign (see page 60) is set to Valid [the default],
whichever Align setting you last used will be saved in memory
and engaged the next time you turn on the printer.
Note This setting does not apply when the printer initializes in
response to an I-PRIME signal.