Filter
Top Products
Microline 8810 User’s Guide
64
Sets the protocol used: Ready/Busy [the default] or
X-ON/X-OFF.
Rcv. Buffer
Sets the amount of memory ( 0 or 128 Kbytes) devoted to
holding received data. The default is 128 Kbytes. Changing this
to 0 will tie up your computer while printing, but if you abort the
print job, the printer will stop much sooner.
Rear Load Adj.
Applies only when the optional Rear Push Tractor is installed.
For fine tuning the Top of Form (TOF) location when using
continuous forms with the rear push tractor. Settable from -40 to
+40 in increments of 1/144 inch. The default is 0.
Negative values decrease the space down from the top of the
form:
•TOF moves up.
•paper moves down.
Positive numbers increase the space down from the top of the
form:
•TOF moves down.
•paper moves up.
Regist. Low
Regist. Normal
Regist. High 1
Regist. High 2
For print registration adjustment These are set at the factory.
Remove Sheet Wait
Applies only when the optional CSF is installed on the rear of the
printer.
Change the setting to Alarm if you want the printer to sound an
alarm when a printed sheet has exited the the rear CSF and is
sitting on the platform.