Microline 8810 User’s Guide
53
Busy Line
Applies only when the optional RS-232C Serial Interface is
installed.
Selects which line your system monitors for a busy signal if the
Ready/Busy protocol (the default) s engaged. Set SSD- [the
default], SSD+, DTR, or RTS.
Busy Time
Applies only when the optional RS-232C Serial Interface is
installed.
Sets the length of the busy signal when the Ready Busy protocol
(the default) is engaged. Select 200 milliseconds [the default],
or 1 second.
Buzzer
The default is Enable. Change to Disable to turn off the printer’s
audible alarm.
Buzzer Volume
Choose the volume of the buzzer: Low [the default], Middle, or
High.
Character Set
Choose the Character Set: Set I [the default], Set II, Standard,
Line Graphics, or Block Graphics (available only when the OKi ML
emulation is selected).
Check Print Area
Applies to manual feed from the platform with Auto Alignment
enabled. Determines whether or not data which is outside the
normal print area specified for the page prints.
The default is Valid: data overflow does not print. This prevents
such data from printing on the platen.
Caution! If you change this setting to Invalid, data could
print directly on the platen and damage the printhead.
Code Page
Choose the Code Page character set you wish to use: USA [the
default], Canada French, Multilingual, Portugal, Norway,
BRASCII, Abicomp, Multilingual 858, or ISO 8859-15.