Filter
Top Products
Microline 8810 User’s Guide
89
Path Changing
Remove Cut Sheet
The printer is attempting to change paper paths from Manual Feed to Front
Feed, but print media is loaded on the platform. Press FF to remove the
media from the platform.
Path Changing
Remove Paper
The printer is attempting to change paper paths from continuous forms to
individual sheets/forms, but print media from the front tractor or the
optional Rear Push Tractor is loaded. Press LOAD to park the continuous
forms.
Press LOAD SW
The printer is waiting for paper to load from the optional CSF. Press LOAD.
Cover Open
Close Cover
Close the top cover.
Paper Feed Alarm
Re-Set Paper
Print media on the platform has miss-fed into the printer. Press SEL, then
press LOAD to eject the media, then try loading it again.
Paper Set Alarm
Re-Set Paper
The paper is not installed correctly. Remove and reinstall it.
Left Margin Err
Check Margin
The left margin setting needs to be adjusted for the print media. Check to be
sure that the Align x Pos. Adjust value you have selected as appropriate.
See page 50.
Head Thermal
Single Pass
The printhead has a thermal sensor which has detected that the printhead is
too hot. The printer has switched to uni-directional printing until the
printhead cools down.
High Duty Print
Single Pass
The print density is high and the printer has switched to uni-directional
printing.