Filter
Top Products
Microline 8810 User’s Guide
67
Change to Tear Up if you do not wish the printer to execute a
form feed before moving the forms to the tear off position.
Time Out Print
If your software spends a long time processing between portions
of data it feeds to the printer, change the setting to Invalid to
keep your printer from dumping the received data while it is
waiting for more.
TOF
Top of Form sets the position down from the top of the page at
which printing starts. The default is 6.35 mm (1/4") from the top
of the page to the vertical middle of the first print line.
Note The amount of adjustment is limited to avoid paper jams.
Manual feed settings: 2.12 mm (1/12"), 3.18 mm (1/8"),
6.35 mm (1/4"), 7.62 mm (3/10"), 8.47 mm (1/3")*, 10.58 mm
(5/12"), 21.59 mm (0.85"), 23.28 mm (11/12"), 25.4 mm (1"),
27.52 mm (13/12"), 1 Chr. Set Pos.
Continuous form settings: 2.12 mm (1/12”), 3.18 mm (1/8”),
6.35 mm (1/4”), 8.47 mm (1/3”)*, 10.58 mm (5/12”), 19.05
mm (9/12”), 21.59 mm (0.85"), 23.28 mm (11/12”), 25.4 mm
(1”), 27.52 mm (13/12”), 1 Chr. Set Pos.
* When 1/3-inch is selected, the distance is from the top of the page to
the top of the first print line, not the vertical middle.
TOF Adj. (Cut)
For fine tuning the Top of Form (TOF) location when using
manual feed from the platform. Settable from -40 to +40 in
increments of 1/144-inch. The default is 0.
Negative values decrease the space down from the top of the
form:
•TOF moves up
•paper moves down.
Positive numbers increase the space down from the top of the
form:
•TOF moves down
•paper moves up.