Filter
Top Products
Microline 8810 User’s Guide
73
5. Adjust the print start position as follows:
a. If you are fine tuning the TOF you set for a preprinted form, you
can move the sheet/form to the position you last set for Manual
Feed 1Chr. Set Pos. by pressing the FF switch.
b. To move the TOF further down on the page (print paper advances
further into the printer):
– In 1/144-inch (0.18 mm) increments: press and hold the SHIFT
switch, then press FF.
– In 10/144-inch (1.76 mm) increments: press and hold the SHIFT
switch, then press SEL.
– One line at a time: press LF.
c. To move the TOF further up on the page (print paper retracts
further out of the printer):
– In 1/144-inch (0.18 mm) increments: press and hold the SHIFT
switch, then press LF.
– In 10/144-inch (1.76 mm) increments: press and hold the SHIFT
switch, then press MODE.
6. Store the TOF position in the printer’s memory:
a. To store the position as the 1Chr. Set Pos setting, press the
SEL switch. The setting will be retained, even if you turn the printer
off, until you use this procedure to change the setting. This also
automatically sets the TOF setting in the Manual Feed group to
1Chr. Set Pos.
Note If you reset the printer to the factory defaults, the 1Chr. Set
Pos you have established will be deleted.
b. To store the position in the printer’s memory only until it is
turned off or receives an I-Prime signal, press the LOAD
switch.
7. Press SEL to return the printer to the on-line state.
Temporary TOF
Use the Control Panel
This TOF setting applies only to the sheet or continuous form loaded into the
printer when the setting is made. The next sheet or form feeds to the
selected default TOF.
1. With paper loaded in the print path, press SEL to put the printer offline.
2. Change the location of the first line of printing:
a. To move the TOF further down on the page (print paper advances
further into the printer):