Filter
Top Products
Microline 8810 User’s Guide
52
The default is No. If you want the printer to automatically add a
carriage return when a Line Feed is received at the end of a line,
change the setting to Yes.
Auto Eject Pos.
This sets when the paper ejects, based on the distance between
the vertical center of the characters on the last line of the page
and the bottom of the page. Choose 3.18 mm (1/8") or 6.35 mm
(1/4") [the default].
Auto Feed XT
The default is Invalid. Change it to Valid if your system uses pin
14 of the parallel interface to control automatic line feed.
Auto Gap Timing
Applies only when the optional CSF is installed.
Normally the gap is detected only on the first sheet when the
path is switched to the CSF. If you want the printer to detect the
gap for every sheet that feeds in from the CSF, change the
setting to Every Paper.
Auto LF
The default is No. If you want the printer to automatically add a
line feed, change the setting to Yes.
Auto Select
If you always use the same Top of Form position, change the
setting to Yes.
Baud Rate
Applies only when the optional RS-232C Serial Interface is
installed.
Select a transmission speed of 300 BPS, 600 BPS, 1200 BPS,
2400 BPS, 4800 BPS, 9600 BPS [the default], 19200 BPS, or
38400 BPS.
Bi-Direction
For the parallel interface, in the nibble mode. To disable the
bi-directional interface, change the setting to Disable.