Filter
Top Products
English
User’s Guide 29
Packaging for return to a Service Centre
With the original box and packaging:
Pack the printer in the original box using the original packing
material by reversing the instructions in “Unpacking the printer”
in your Setup Guide.
Note: Please do not ship the Power Cable, Printer Cable, Printer
Driver Disks, User Guide, Print Head, Storage Box or Ink
Cartridges unless instructed to do so.
Without the original box and packaging
Printer
Outside box -
275 lb test box
Two layers 12.3mm (0.5")
bubble wrap
Minimum 50.8mm (2"
)
loose fill
1. Remove the Print Head and place it in the Print Head Storage
Box. Do not return the Print Head.
2. Close Carriage Cover and Paper Tray. Remove Power Cable
and disconnect the printer cable.
Note: Please do not ship the Power Cable, Printer Cable, Printer
Driver Disks, User Guide or Ink Cartridges unless instructed
to do so.
3. Place the printer in a large plastic bag.
4. Completely wrap the printer in 2 layers of bubble wrap
(minimum 12.3mm (0.5")) thick and tape the bubble wrap to
keep it in place.
5. Select a corrugated box large enough to allow at least 50.8mm
(2") between the bubble-wrapped printer and the walls of the
box.
Note: The strength of the box should be 275 lb test.
6. Fill the bottom of the box with 76 mm (2 to 3") of loose fill.
7. Place the bubble-wrapped printer in the centre of the box.
Outside box -
275 lb test box
Two layers 12.3mm (0.5")
bubble wrap
Minimum 50.8mm (2")
loose fill
2500ugb.p65 02/06/98, 11:3329