Filter
Top Products
English
User’s Guide 33
Appendix B
Transportation Precautions
The OKIJET 2500 is not designed to be a portable printer, but it
may be easily moved within your home or building. If, however,
transportation involves any of the conditions below, you will need
to take special precautions with the colour printhead and ink
cartridges to avoid potential ink leakage.
• Airplane travel
• Elevation changes greater than 300m
• Temperature changes greater than 10
o
C
For transport by road of one hour or less that does not involve
changes in elevation or temperature greater than that stated
above:
1. Press and release the Cartridge Change/Clean button. Open
the printer cover and remove the colour printhead and ink
cartridges as a single unit.
2. Place the printhead and ink cartridges in the storage box that
came with the printer.
3. If you have a monochrome printhead, place it in the printer.
4. Press and release the Cartridge Change/Clean button again.
After the printer completes its cycle, turn the printer off.
5. Remove all paper from the paper tray and output shelf areas.
Disconnect all cables.
Your printer is now ready for transportation.
6. You may place the printer anywhere in the vehicle where it
will be protected from movement, and vibration. For example
on the floor of the rear seat.
7. Place the storage box (with the colour printhead) inside the
vehicle in an area that will be kept at a comfortable temperature.
(Ink leakage may occur if large rapid temperature changes are
experienced).
8. As soon as possible after reaching your destination, remove
the printer and storage box and place them in a location where
the temperature is maintained between 15
o
C to 35
o
C.
9. Connect the printer to the AC mains.
10. Press and release the Cartridge Change/Clean button and re-
install the colour printhead. If the monochrome printhead was
in the printer, put it in the storage box.
2500ugb.p65 02/06/98, 11:3333