Filter
Top Products
3
301 Fulling Mill Road, Suite G ©Copyright 2004 by OnQ Technologies, Inc All Rights Reserved.
Middletown, PA 17057 www.onqhome.com
(800)-321-2343
Innovations in Home Living.
D. On-Q Home 4 Port Router/Switch Detailed Physical Description
The following information describes the physical characteristics of the On-Q Home Router/Switch:
1. Router/Switch Module Connection Area
Figure 2 shows the Router/Switch connection area including:
9 VDC Power Receptacle – connection from power supply
WAN (Network) Port – 8 position RJ-45 jack (connects to Cable or DSL modem)
Local Switch Ports – 8 position RJ-45 jacks (connection from outlets in rooms)
Reset Button - A dual-function button. A brief button press (with a pencil, pen, or other pointed object)
resets the Router/Switch unit, while a longer button press (over 5 seconds) resets the Router/Switch unit to
the factory default settings. If the Router/Switch is experiencing trouble connecting to the Internet, briefly
press and release the Reset button to reset the unit. The Router/Switch will retain its configuration
information during this reset operation. To reset the unit to the factory defaults, while the unit is powered,
press and hold the Reset button for more than 5 seconds. This clears the user settings, including User ID,
Password, IP Address, and Subnet Mask.
NOTE: Refer to Section IV Configuration for instructions on re-configuring the Router/Switch.
2. Router/Switch Status LEDs (see Figure 2)
Power – On solid green when power is supplied.
Status LED – On solid red indicates device is not working properly. Blinks red during power-up.
WAN (Network) LED – On solid green to indicate connected and linked to a Cable or DSL Modem.
Blinks green to indicate receiving or sending data over the network.
Local Switch Port LEDs– On solid green to indicate proper connection to a local device (PC Network
Interface Card). Blink to indicate receiving or sending data.
Figure 2
Local Switch PortsNetwork Port9 VDC Input
Power LED Status LEDSwitch Port LEDs WAN LED
Reset Button
STATUS