Filter
Top Products
Manual No. 25-ULPNR101-03; Feb, 2003 LPN5627 / LPR5627 Laser Fixed Mount
Scanner
Page 19
Appendix B
Computer Programming Commands
All commands must be preceded by an 'ESC' character and be followed by a 'Carriage Return' character.
Shaded areas indicate factory default settings.
Enable Disable
Global Defaults
U1 Enable Factory Default Settings
1Y Clear all prefixes
1Z Clear all suffixes
P9 Transmit Barcode Pattern Data
U8 Read Rate Test Mode
Z1 Clear all values set by command
Z2 Save all values set by command
Z3 Display software settings &
version no.
Z4 Display prefix/suffix
Only Add Rmv
Symbology Selection
A0 Enable all symbologies
A1 B1 4A WPC (including add-ons)
A2 B2 4H Code 39
A3 B3 4I Codabar (NW-7)
A4 B4 4J 2 or 5 Industrial or Interleaved
J7 R7 4K 2 or 5 Industrial
J8 R8 4L 2 or 5 Interleaved
A5 B5 4M Code 93
A6 B6 4N Code 128
A7 B7 4O MSI/Plessey
A8 B8 4P IATA
J1 R1 4B UPC (A/E)
J2 R2 4C UPC (A/E)+2
J3 R3 4D UPC (A/E)+5
J4 R4 4E EAN
J5 R5 4F EAN+2
J6 R6 4G EAN+5
4Z Disable all Symbologies
Enable Disable
Options for UPC
E2 UPC-A (13 Digits) Leading zero &
CD
E3 UPC-A (12 Digits) No leading 0 &
CD
E4 UPC-A (12 Digits) Leading zero &
No CD
E5 UPC-A (11 Digits) No leading 0 &
no CD
E6 UPC-E (8 Digits) Leading 0 & CD
E7 UPC-E (7 Digits) No leading zero
& CD
E8 UPC-E (7 Digits) Leading zero; no
CD
E9 UPC-E (6 Digits) No leading 0 &
no CD
Enable Disable
Options for Code 39
7C 7D Enable 1 character read
C1 C0 Enable Check Digit calculation
C2 C3* Transmit Check Digit
D1 D0 Transmit start/stop characters
(*…..*)
• Only disable if C1 enabled, otherwise
truncate last digit.