Filter
Top Products
Manual No. 25-ULNFT2100-01; Mar, 2005 NFT 2100 CCD Fixed Mount Barcode
Scanner
Page 38
13. Setting the Character length that is allowed to be read.
Computer
Command
Function
/Description
Bar Code
Command
(ZZ)
START/END
Programming Menu
[[
H0
Disable length setting on all
symbologies
I1
%
H1
Enable length setting on all
symbologies
I2
HK
Enable length setting for selected
codes
IL
HL
Enable minimum length for
selected codes
IM
HM
Enable maximum length for
Selected codes
IN
To avoid truncation errors, the scanner can be programmed to only decode bar codes of one specific
length, i.e., containing a specific number of digits. It is also possible to program the scanner to only
decode bar codes of either of two specific lengths.
To set one or two lengths for all
symbologies:
1.
Scan “START” to enter the
programming mode.
2.
Scan “Enable length setting (H1)
for all symbologies”.
3.
Scan a sample bar code of
the desired length.
4.
Repeat Step #3, re-scanning
the sample bar code length or a
different bar code length to get 2
lengths.
5.
Scan “END” to exit the
programming mode
To set one or two lengths for selected
symbologies:
1.
Scan “START” to enter
the programming mode
2.
Scan “Enable length setting (HK)
for selected symbologies”.
3.
Scan a sample bar code of
the desired length #1
4.
Repeat Step #3, re-scanning
the sample bar code length or a
different bar code length to get 2
lengths.
5.
Scan “END” to exit the
programming mode
“Setting the Number of Digits” can only be applied to Code 39, NW-7, 2 of 5, and MSI/Plessey. WPC,
Code 93, IATA, and Code 128 are not affected.
Setting Minimum/Maximum Length
This option modifies the default minimum length table. To use this option, perform the following steps:
1.
Scan “START” to enter the programming mode
2.
Scan “Enable minimum length for selected codes” (HL)
3.
Scan bar codes of the
required type and length
.
4.
Scan “END” to end the programming sequence.