Filter
Top Products
E-10
ENGLISH
Control reference guide
Front
POWER button
Use this button to turn the unit ON and OFF.
When the unit is OFF, simply press the
[POWER] button to turn it ON. When ON, hold
the [POWER] button for at least two seconds
to turn it OFF.
POWER LED
Lights when the unit is ON.
The POWER LED flashes during startup or
shutdown.
P2C button
Press to format P2 cards. After copying data to
the HDD, you can format the P2 card as
needed. (See page E-17)
Note:
Data cannot be recovered after formatting.
Before formatting cards, make sure all the
data may safely be deleted.
HDD button
Press to format the internal HDD. All unneeded
data on the HDD can be deleted at once.
(See page E-18)
Note:
Data cannot be recovered after formatting.
Before formatting the HDD, make sure all the
data may safely be deleted.
P2C LED
Lights or flashes when the unit is accessing a
P2 card.
(See pages E-16, E-17 and E-28)
HDD LED
Lights or flashes when the unit is accessing the
internal HDD.
(See pages E-16, E-18 and E-28)
ERROR LED
Lights or flashes if errors occur.
Errors are identified by the combination of
[COPY STATUS] LEDs on the front and [E1 to
E4], [P2C], and [HDD] LEDs on the top.
(See pages E-15 and E-29 to E-31)
P2 card slot
A dedicated slot for P2 cards. Before inserting a
P2 card, make sure the EJECT button is in.
Hold the card level as you insert it.
Never insert anything in the slot except P2
cards.
EJECT button
Press to eject P2 cards from the slot.
(See page E-13)
COPY STATUS LEDs
Indicates the progress of copying or formatting.
(See pages E-16, E-17, E-18, E-28 and E-31)