Filter
Top Products
E-30
ENGLISH
ERROR LED display (continued)
REMAIN
No.
R
R R
Status
A S.M.A.R.T error has
occurred on the internal HDD.
Corrective Action
There may be a problem with the
internal HDD. If it contains data
you need, first clear the error
display
1)
, and then back up the
data on a different storage
media, and contact the place of
purchase.
R
R R R R
After an internal error
occurred, copying and
formatting is not possible.
R
R R R R
An error occurred during
updating.
R
R
Copying failed, after which the
unit was turned ON and the
error occurred.
After clearing the error display
1)
,
try copying the data again.
Execute [Quick format] again.
Execute [All erase] again.
R
R
[Quick format] failed, after
which the unit was turned ON
and the error occurred.
R
OR
[All erase] failed, after which
the unit was turned ON and
the error occurred.
R
R
R
Corrections are not applied.
The unit’s internal settings
cannot be adjusted, so an
error occurs.
There may be a problem with the
unit. Contact the place of
purchase.
R
OR
The internal lithium battery is
drained.
Contact the place of purchase
and replace the lithium battery.
Once this error is displayed, it
will continue to be displayed
when the unit is turned ON until
you replace the lithium battery.
R
R R R
R
The sensor has detected impact
to the HDD while writing
administrative data or an HDD
access error has occurred.
Turn the unit OFF and ON.
After placing the unit on a stable
surface, copy the data.
R
R R
R
An error has occurred in the
control information of the
internal HDD.
If the data is important, back it up
on a different recording media,
and proceed with [Quick format].
R
R R
A [Quick format] error has
occurred on the internal HDD.
R
17
21
22
18
19
20
23
24
25
26
15
16
R
R
An [All erase] error has
occurred on the internal HDD.
There may be a problem with the
internal HDD. Contact the place
of purchase.
After clearing the error display
1)
,
try formatting the card again. If
the error recurs, switch P2 cards
and try formatting again. If the
error persists even after this,
contact the place of purchase.
R
R
A formatting error has
occurred with the P2 card.
(Other than write-protection or
pulling out a P2 card)
14
1) To clear the error display, press the [POWER] button and [CANCEL] button together.