Panasonic CF-18 Series Laptop User Manual


 
18
Operation
Starting Up/Shutting Down
The power saving function is factory set, so if there is no input from a key, the touch
pad, the tablet button, the touchscreen or an external mouse (when one is connected)
for a certain interval of time, the power to the LCD and hard disk may be turned off.
The LCD will resume operation when the touch pad, the touchscreen or an external
mouse (when one is connected) is used or a key or the tablet button is pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode. The computer will resume by sliding the power switch. (
“Standby/Hibernation Functions”)
NOTE
3
Log on to Windows.
After confirming that the hard disk drive indicator has turned off, select the user and
input the password, then select
. Until the correct password is entered, the computer
will not operate.
4
Select your application.
You are able to start working on your computer.
Enter your password*
1
and press Enter . ( “Security Measures”)
Will Start
Will Not Start
(Power off)
If [Enter Password] is displayed,
*
1
Supervisor Password or User Password set in the Setup Utility (not the
Windows password).
Three incorrect attempts
or
No password for about a
minute
The correct password
Enter Password [ ]