Filter
Top Products
25
Display Panel Instructions
Imprinter setting menu (by pressing the IMPRINT key)
Both a pre-imprinter and post-imprinter can be installed at the same time. However, the operator may only use
one imprinter at a time. If both of the imprinters are installed, you can set the following conditions.
Number, item and default display
• Pressing the
3
key will change to the
next mode.
• Pressing the
4
key will change to the
previous mode.
Contents
• Pressing the
1
key or the
2
key will change to another value.
01 Setting the pre-imprinter data
• This setting can be done only when a
pre-imprinter is installed.
Host :
Count :
Printing will be done according to the host computer.
Printing will be done according to the counter in the
“Select counter displayed on the LCD”.
02 Setting the pre-imprinter position
• This setting can be done only when a
pre-imprinter is installed.
By pressing the
1
key or the
2
key, you can specify the line
where printing starts from the top of the document. If “0”
character is set, printing starts from 10.0 mm.
The millimeter value displayed is an approximation.
The length per character varies, depending on the 04 orientation
setting.
90°or 270°: 2.40mm per character
0°or 180°: 3.46mm per character
Character: 0 - 72
• In this example, printing starts at 12.4 mm (approx. 1/2 in.)
from the top of the paper. The number 12.4 can be changed
from 10.0 to 182.8 by pressing the
1
key or the
2
key.
03 Setting the pre-imprinter font style
• This setting can be done only when a
pre-imprinter is installed.
Bold :
Normal:
2-dot font
1-dot font that can increase the ink lifetime longer than
Bold fonts.
01.Pre I
Hos t
mp r i n t
CountHost
02.Pre P
Hos t
osition
02 .Pre P
osition
1Cha r
12.4mm
Top of the paper Top of the paper
Top of the
printout
ABCD
......
ABCD
......
Top of the
printout
10mm (Default)
12.4mm
Approx.
1/2 in.
Approx.
13/32 in.
03.Pre
Hos t
Font
NormalBoldHost