Filter
Top Products
37
Cleaning the Unit
3
Use the accessory roller cleaning
paper (KV-SS03) to remove the dirt
from the surfaces of all rollers.
•
When wiping off the dirt, hold the rollers
to prevent them from rotating. Wipe the
rollers all the way around from one end to
the other in the directions of the arrows
shown on the diagram to the right.
• Perform the retard roller cleaning only in
the left direction. If cleaned in the right
direction, the roller may slip out of the
proper position.
• When cleaning the rollers in the back of
the bottom scanning section glass
(rollers of part A), do not touch the tip of
the plastic pointer (black) in the back of
the unit.
Set the paper path selector as shown
below. When the tip of the pointer is
raised, the tip may cause an injury.
Retard rollers
Pointer
A
For roller cleaning,
pull the belt in the
direction of the
arrow to rotate
the rollers.
Belt
Retard rollers
Other rollers
• The rollers to be cleaned are shaded.
• Wipe in the direction of the arrows.
Left side view
Paper path
selector
The paper path selector is located on the
left side of the scanner.