Filter
Top Products
40
Cleaning the Unit
¥ Re-attachment of the sensor roller
When the sensor roller is removed while cleaning the inside of the scanner, re-attach it as shown below.
Lower sensor roller:
Attach the roller by placing the gear side to
the left side of the scanner and inserting
both side’s bearings into the guide grooves.
•
After attaching, press down on top of the sensor
roller with your finger to confirm if it moves or
not.
Upper sensor roller:
1 Attach the roller by inserting the bearing
of the gear side of the roller into the guide
groove on the left side of the scanner.
•
Match the flat side of the bearing with the
flat side of the guide groove.
2 Hold the shaft on the right side of the
sensor roller, push the tip of the gear, and
slide the sensor roller in the direction of
the arrow
Œ
.
Then attach the roller by inserting the
bearing of the non-gear side of the roller
into the guide groove on the right side of
the scanner.
•
Match the flat side of the bearing with the
flat side of the guide groove.
∫∫
∫∫
Roller cleaning paper
Open the bag on the dotted line and take out
the roller cleaning paper.
•
If the bag is left open for a long period of time,
the alcohol will evaporate.
Please use the roller cleaning paper
immediately after opening the bag.
§ The roller cleaning paper (Model No. KV-SS03) is available from the dealer where you
purchased your scanner.
For supplies and accessories: Call 1-800-346-4768 (U. S. A. only) or your dealer.
Gear
Bearing
Sensor roller
Guide groove
Please attach the right side bearing in the same way.
Gear
Bearing
Sensor roller
Guide groove
1
2
Dotted line